![]() If your cutting came with a test pen, try that but still keep the speed moderate. Also, with a pen you don't get rounded corners at all because pens do not need a Blade Offset setting. Personally, when I calibrate a new cutter, I use the test pen and paper in order to minimize anything related to (4). If you are cutting paper, the paper should be mounted onto a cutting mat and not cutting into the mat at all. ![]() If you are cutting vinyl, then make sure the blade isn't penetrating the backing sheet. (4) Make sure the blade isn't over extended. (2) Make sure the pinch wheels and grit shafts are clean and not at all sticky If even one pinch wheel is half/on - half/off a pinch wheel that can lead to skewing (1) Pinch wheels are not centered with the grit shafts below. If the left/right sides and up/down sides are not the same length, that is an issue with the cutter. Let's assume that the next cut measures at 249.5, then the calculation would be:Īnd you continue until both sides are perfect.ĭid you read my additional post when I realized I had forgotten to address the Blade Offset and Overcut issue? That's the number you would enter and you would then repeat the cut. So, the Resolution is a ratio: (Measurement on screen) divided by (Measurement of actual cut) times (Current Resolution entered in SCAL) So, if your first cut of a 250 mm square indicated that X was ~ 248.5 mm, then your calculation would be: It varies based on the brand and model but, in general, X is up/down on a vinyl cutter so assume that if you don't already know for sure or your user manual doesn't specify. and then Y would be, of course, the opposite. Now, you need to know if YOUR model has X going up-and-down or left-to-right as you face the cutter. Then you cut it out and measure it as accurately as possible with a ruler. You want it fairly large to get a more accurate result. The way to calculate those two Resolutions is to add something like a 10" x 10" square in SCAL OR use mm and make it 250 mm x 250 mm. In the top left corner you'll see X Resolution and Y Resolution. In SCAL, go to Cutter>Cutter Settings OR in the Cut Settings window, click on the Settings button to the right of where you have the Model selected.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |